Installation Guide DAMPA Space eng - Flipbook - Side 5
8
The worktop is mounted with bolts through the wall rails at the
ends of the worktop mounting rail.
The wall rail covers are mounted to the wall rails by clamping the
profiles into the opening of the wall rails.
DAMPA® Space I Installation Guide
7
Other worktop heights follow the same procedure, using the other
holes.
9
The magnetic catches for the doors are mounted in the slots of
the shelf support, with the magnet facing towards the door.
10
The doors are mounted onto the lower ratchet of the wall rails,
after which the upper wall rail fitting is mounted to the door and
into the wall rail.
If the door height needs fine adjustment, this is done by placing
washers on the ratcher at the bottom of the wall rail.
Once the doors are adjusted, the wall rail fitting is secured to the
wall rail with a bolt.
11
The handles are mounted in the centre of the door using pop
rivets, by drilling four holes in the sides of the door and fastening
the handles with pop rivets.
The handles must be positioned directly against the inside of the
door to allow sufficient space to grip the handles on the front of
the door.
Finally, the table lock is mounted on the inside of the wall rail.
When installing more than one DAMPA® Space side by side, it is
recommended to leave a minimum gap of 10 mm between units.
5
