EPD 75 post consumer aluminium marine EPD HUB-3727 - Flipbook - Side 10
Averages and Variability
Type of average
Multiple products
Averaging method
Averaged by shares of total mass
Variation in GWP-fossil for A1-A3 (%)
The variation in GWP-fossil for A1–A3 among the
products included in the EPD is - 10 % to + 7 %,
measured as the range from the lowest to the
highest value within the group.
The following products have been included in the calculation of an average EPD:
Clip-In
DCC
Interval
Panel
300x300
300x600
400x400
500x500
600x600
600x1200
590x590
590x1190
Custom
300/xxx/25
500/xxx/25
600/xxx/15
2000/xxx/0
3000/xxx/0
5000/xxx/0
6000/xxx/0
200/xxx/25
40x55x40
40x30x40
60x30x60
100x30x100
50x50x50
60x50x60
100x75x100
90/10
190/10
290/10
31/xxx/45
32/xxx/45
33/xxx/45
D-10/20
D-50/xxx/20
D-100/xxx/20
D 140/xxx/10
D-150/xxx/ 20
D-200/xxx/20
D-300/xxx/20
D-200/xxx/10
D-150/xxx/0
DT 300
DZ-2000/xxx/0
DZ-3000/xxx/0
All products included in this declaration are manufactured at the same production site, ensuring
consistency in production processes and energy sourcing. The production processes and raw
material inputs across the product group are of a similar type, in compliance with the requirements
for process and material similarity outlined in Section 2 of Annex I.
A representative product was selected for the development of a baseline LCA model. Based on this
baseline, an assessment of the variability in GWP-fossil (A1-A3) was conducted by adjusting the
key input and output flows to reflect a minimum and maximum case within the group. The variation
in GWP-fossil for the assessed product group was found to remain within the permissible threshold
of ±50%, as required for average EPDs.
9
75% Post Consumer Aluminium | Marine
