DAMPA 100 200 300 - e-katalog - Catalog - Page 7
1
2
3
Splicing of Carriers
Securing the Units
Closed Jointing Details
Modular Carrier No. 40 is provided with
pre-punched lugs and cutouts for modular
splicing.
If necessary, the ceiling units can be
locked in position by pushing down the
reverse clip behind the wide flange.
Closed joints are formed under Modular
Carrier No. 43 (double carrier) rigidly
suspended from the deckhead above.
Locate the carrier ends so that the cutouts
overlap and lock together by folding the
lugs inwards.
For DAMPA® 10 use the longer reverse
clips and for DAMPA® 100/200/300 use
the shorter of the two.
Only the DAMPA® 10 ceiling, using a splice
inlay, can be butt jointed without end
closings. Locate the splice inlay in the unit
and hold in position while securing to
carrier. Install secound unit to complete
the closed joint. The splice inlay must not
be pushed into the units after installation.
4
5
Featured Joint
Curved
Featured joints of DAMPA® 200 and 300
ceiling units are formed under Modular
Carrier No. 43 (double carrier) rigidly
suspended from the deckhead above.
The carrier is fastened at 300 mm
centres to a pre-shaped hard core or
metal structure spaced at 1200 mm
centres maximum.
In this case the carriers are to be ordered
in painted execution.
Curved surfaces of DAMPA®
10/100/200/300 ceiling units to a radius of
20 m or more, corresponding to an arch of
100 mm over a span of 4 m, may be formed with standard Modular Carrier No. 40
suspended from standard hangers.
Weight
Dismantling
The average weight of a
DAMPA® 10/100/200/300 ceiling
including suspension components is as
low as 2.7 - 3.4 kg per sq.m depending
on type and execution.
It is possible to remove and reinstale
individual ceiling units without the use
of tools.
For specific project-related weight
calculations, please see the weight
of each item.
To remove, pull the unit towards you
horizontally and simultaneously push
the nearest adjacent one
7
